1. Create a directory to do our work in
mkdir ~/ffmpeg
cd ~/ffmpeg
2. Get all the source fileswget http://www3.mplayerhq.hu/MPlayer/releases/codecs/essential-20061022.tar.bz2
wget http://rubyforge.org/frs/download.php/9225/flvtool2_1.0.5_rc6.tgz
wget http://easynews.dl.sourceforge.net/sourceforge/lame/lame-3.97.tar.gz
wget http://superb-west.dl.sourceforge.net/sourceforge/ffmpeg-php/ffmpeg-php-0.5.0.tbz2
wget http://downloads.xiph.org/releases/ogg/libogg-1.1.3.tar.gz
wget http://downloads.xiph.org/releases/vorbis/libvorbis-1.1.2.tar.gz
3. Extract all the source files
bunzip2 essential-20061022.tar.bz2; tar xvf essential-20061022.tar
tar zxvf flvtool2_1.0.5_rc6.tgz
tar zxvf lame-3.97.tar.gz
bunzip2 ffmpeg-php-0.5.0.tbz2; tar xvf ffmpeg-php-0.5.0.tar
tar zxvf libogg-1.1.3.tar.gz
tar zxvf libvorbis-1.1.2.tar.gz
4. Create the codecs directory & import them
mkdir /usr/local/lib/codecs/
mv essential-20061022/* /usr/local/lib/codecs/
chmod -R 755 /usr/local/lib/codecs/
5. Install SVN/Ruby (Depends on OS, this is for RHEL/CentOS)
yum install subversion
yum install ruby
yum install ncurses-devel
6. Get the latest FFMPEG/MPlayer from the subversion
svn checkout svn://svn.mplayerhq.hu/ffmpeg/trunk ffmpeg
svn checkout svn://svn.mplayerhq.hu/mplayer/trunk mplayer
7. Compile LAME
cd ~/ffmpeg/lame-3.97
./configure
make
make install
8. Compile libOGG
cd ~/ffmpeg/libogg-1.1.3
./configure
make
make install
9. Compile libVorbis
cd ~/ffmpeg/libvorbis-1.1.2
./configure
make
make install
10. Compile flvtool2
cd ~/ffmpeg/flvtool2_1.0.5_rc6
ruby setup.rb config
ruby setup.rb setup
ruby setup.rb install
11. Compile MPlayer
cd ~/ffmpeg/mplayer
./configure
make
make install
12. Compile FFMPEG
cd ~/ffmpeg/ffmpeg
./configure --enable-libmp3lame --enable-libvorbis --disable-mmx --enable-shared
echo '#define HAVE_LRINTF 1' >> config.h
make
make install
13. Finalize the codec setups
ln -s /usr/local/lib/libavformat.so.50 /usr/lib/libavformat.so.50
ln -s /usr/local/lib/libavcodec.so.51 /usr/lib/libavcodec.so.51
ln -s /usr/local/lib/libavutil.so.49 /usr/lib/libavutil.so.49
ln -s /usr/local/lib/libmp3lame.so.0 /usr/lib/libmp3lame.so.0
ln -s /usr/local/lib/libavformat.so.51 /usr/lib/libavformat.so.51
14. Compile FFMPEG-PHP
cd ~/ffmpeg/ ffmpeg-php-0.5.0
phpize
./configure
make
make install
15. Install FFMPEG-PHP (make sure the php.ini path is correct.)
echo 'extension=/usr/local/lib/php/extensions/ no-debug-non-zts-20020429/ffmpeg.so' >> /usr/local/Zend/etc/php.ini
16. Restart Apache to load FFMPEG-PHP (Depends on OS, this is for RHEL/CentOS)
service httpd restart
17. Verify if it works
php -r 'phpinfo();' | grep ffmpeg
If you get a few lines such as
ffmpeg
ffmpeg support (ffmpeg-php) => enabled
ffmpeg-php version => 0.5.0
ffmpeg.allow_persistent => 0 => 0
Then everything is installed and working. FFMPEG, FFMPEG-PHP, MPlayer, MEncoder, flv2tool, LAME MP3 encoder & libOGG.
—————————————————————————————————————————————————
Common Errors may occur
1. When you try to ‘make ‘libVorbis you may get an error ” checking for ogg >= 1.0… checking for Ogg… not found ”
Solution : Install libogg ( yum install libogg ), then Make it again




November 25th, 2009
Aneesh
Posted in 

I was trying to install ffmpeg-php on Fedora9, I’ve downloaded the ffpmeg-php-0.6.0 and used phpize and ./configure –enable-shared –prefix=/usr and both of them worked fine but when I tried to run make I got the following error:
“make: *** No targets specified and no makefile found. Stop.”
I tried the same procedure with ffmpeg-php-0.5.1 and ffmpeg-0.5.0 but failed.
Can anyone help with this.
Is there any error up to 13the steps ?
No not at all, every step went smothly without any error. Its just the make command which is not working…
I cannot duplicate it here. Any way please remember FFMPEG will work if you completed up to 13th Steps (including 13th step). If you cannot open FFMPEG, just add the lib path in ld.so.conf file and run ldconfig
I’ve got one error : Typing ffmpeg -v
ffmpeg: error while loading shared libraries: libavcodec.so.52: cannot open shared object file: No such file or directory
Can you help me please ?
Hi,
Make sure that you have installed Codec. If so , locate the file libavcodec.so.52 and add the location to ldconf. Then update ldconfig. It should work
Aneesh
Thank you Aneesh. I’ll try tonight.
See you